Actiontec electronic GT701-WG - Manual (Page 54)

50
Actiontec 54 Mbps Wireless DSL Gateway User Manual
51
Chapter 5 Setting Up Static IP
12. The “Save and Restart” page appears. Click “Save and Restart” to save the set-
tings changed in the Change Admin Password screen.
The Gateway has been configured to support a single static IP address. Once the
Power light stops blinking, the Gateway is ready for use.
Configuring for a Block of Static IP Addresses
To set up the Gateway to use a block of static IP addresses:
☞
Note: To complete this procedure, you must have access to the
Internet Service Provider ( ISP
) worksheet. If no worksheet has
been provided, contact the ISP .
1. Open the Web browser. In the address bar enter:
http://192.168.0.1
then press Enter on the keyboard.
2. The “Main Menu” screen appears. Select Setup/Configuration.