Actiontec electronic GT701-WG - Manual (Page 65)

62
Actiontec 54 Mbps Wireless DSL Gateway User Manual
63
Chapter 6 Advanced Setup
Encapsulation
If the Gateway is configured to obtain an IP address through DHCP or to specify a
static IP address, select the appropriate encapsulation option used by the ISP ( RFC
1483 Bridged or RFC 1483 Routed).
☞
Note: Contact the ISP if unsure of the proper configuration.
Unnumbered Mode/VIP Mode
If a block of public static IP addresses was purchased from the ISP , select
Unnumbered Mode by clicking in the appropriate check box. Then, enter the IP
Address and Subnet Mask in the “Gateway Address” and “Unnumbered Subnet
Mask” text boxes below the “Unnumbered
IP Address.” Click Next, then click Save
and Restart to make all changes permanent.
The Unnumbered Mode feature automatically configures the appropriate
IP rout-
ing for the IP Address block. The IP route will bypass NAT , enabling the public IP s
to be routed WAN -to- LAN , as well as LAN -to- WAN .
☞
Note: The IP Address information should be obtained from the
ISP when purchasing a block of public static IP address. Contact
the ISP if this information was not received.