Lyndex-Nikken Shrink Fit Machine Instructions User Manual
Page 6
ELCO
Shrink fit unit Start.2
27/04/2010
Page 6/19
- electricity : make sure that the unit is properly switched on with an adequate plug on
a protected network able to feed with 3x200V/240V-50Hz/60Hz, 32A and equipped with
a circuit-breaker 32A curve C and with a differential 30mA
In case of deterioration of the inductor, switch the unit off and disconnect it.
In any case, before pulling the electronic rack out, switch the unit off and disconnect it.
The unit shall never be opened without any written authorisation of the manufacturer
and in any case, it must be switch off from the electric network before any intervention.
In general, if any dysfunction is noticed or any tool damaged, the unit is to be stopped,
unplugged from the electric network, and must be mentioned to the manufacturer after-
sales department before restarting.