Lyndex-Nikken Shrink Fit Machine Instructions - Manual (Page 8)

ELCO Shrink fit unit Start.2 27/04/2010
Page 8/19
3 – TRANSPORTATION AND PACKAGING
3.1 Transportation
The manufacturer has done whatever is necessary concerning the packaging so that
the transportation does have any consequences on the unit.
If any irregularities are noticed at the delivery, it is up to the receptionist to make the
remarks and reservations on the delivery note so that the carrier’s responsibility is
involved.
In no case the responsibility of the manufacturer should be involved.
3.2 Unpacking
Take the unit out of its packaging and check if the goods are in accordance with the
delivery note.
4 – STARTING UP
4.1 Setting the unit up
The setting up and starting up of the unit can only be done by a manufacturer’s
technician and this will confirm the beginning of the warranty period.
The unit must be installed on a steady and horizontal work surface, capable to
withstand its weight.
4.2 Installing the unit
Separate remote control plugging :
Unpack the remote control and plug the sub-D connector into the plug located on the
front of the shrink fit unit and lock the screws.
It is essential that when you connect or disconnect the remote control, the unit is
switched off.