MagTek Excella, MICR Check Reader99875310 - Manual (Page 21)

15
SECTION 3. OPERATION AND MAINTENANCE
This section contains powering, operating, and maintenance procedures. Ensure the Excella is
installed and cabling and power are connected as described in Section 2.
POWER UP
Plug the power supply, P/N 64300098P/N, and cord 71100001, into wall power, and press the
start button. The green LED closest to the front of the unit should light.
TILT-DOWN CHECK STOP
The Tilt-Down Check Stop, shown in Figure 2-1, is used for both single and multiple check
feed. For business size checks (long), place the Tilt Stop in the down position. For personal size
checks (short), place the Tilt Stop in the up position. (See Appendix B for check sizes.)
OPERATOR BUTTON
The Operator Button is commonly used to communicate to the PC application that an
unexpected condition or error has been cleared and Excella is ready to go again. For example, if
there is paper jam, the Middle LED will flash red. After the paper jam is cleared, the user must
press the Operator Button to resume the check reading/scanning operation.
OPERATION
Checks may be entered manually (one check at a time) or automatically (up to 70 checks at a
time). Consult Section 2, Figure 2-1, for locations of the components described here.