Scan bars and card path, Clearing the check path – MagTek Excella, MICR Check Reader99875310 User Manual
Page 26
Excella MICR Check Reader
20
Damp Wiping Nozzles
Perform the following steps:
1. Dampen a clean, lint-free cloth with water.
2. Hold the dampened cloth or tissue in contact with the nozzles for a few
seconds.
3. Then gently wipe the nozzle plate.
Caution
Do not wipe the electrical contact area.
4. If ink remains on the nozzle plate, wipe again with a clean dry cloth.
Scan Bars and Card Path
Check the Excella paper path to ensure there is no build-up of ink or paper debris, and clean. To
clean the Scan Bars, use the Cleaning Swab, P/N 97200078, as shown in Figure 3-6.
Figure 3-6. Cleaning Scan Bars
Clearing the Check Path
Clear debris or remove a check from the path as follows:
1. Open both Outside Entry and Exit Guides as shown in Figure 3-7.
2. Clear debris or pull out the checks from the path.
3. Examine the check path to ensure there is no additional debris, dust or other
extraneous material in the path.