MagTek InSpec 9000 - Manual (Page 23)

13
SECTION 3. OPERATION
The operation of the Tester includes opening the tester program, cleaning, reading cards and
interpreting the results, obtaining performance charts and interpreting trends. Also included in
this section are descriptions of Windows-style buttons and Tester icons on the main screen.
OPENING THE TESTER PROGRAM
After the InSpec Tester program is opened from Windows, a picture of the Tester with the
version number will appear as shown in Figure 3-1. In this example the unit is installed, and the
firmware version number and the Unit ID are listed. When the unit is not properly installed, the
message “Unit Not Installed...” appears where the firmware and ID numbers are.
Figure 3-1. Opening Display
This screen will disappear in a few seconds leaving the main screen showing.