MagTek InSpec 9000 - Manual (Page 28)

InSpec 9000 Encoded Card Tester
18
SECURITY
The security features in the InSpec 9000 are used to restrict access to certain data. These
features are accessed by selecting Setup from the main screen, then Software, then Security. The
current password must be entered to access the security form. The default password is
“password”. Passwords are case sensitive; p is not the same as P. The Security screen is shown
in Figure 3-4.
Figure 3-4. Security Screen
To change the current password, type the new password in the test boxes labeled New and
Confirm. Click on the OK button to change the password.
As shown above, the security features have two states, standard restriction and Administrative
Override. The standard restriction is the security level that is used when the software starts up or
the Security Reset (on the Main Screen) has been clicked. Administrative Override is to allow a
supervisor to enable the visibility of certain data for a limited time.