Campbell Scientific CC640 Digital Camera - Manual (Page 23)

CC640 Digital Camera
TABLE 6. Explanation of Configuration Settings
Parameter Type Description Default
Value
Version Read
Only The firmware version of the CC640 operating system N/A
PakBus Port Read/
Write Options: NONE, CS I/O, RS-485, RS-232
Only select a PakBus Port if communication is being used to
transfer images via PakBus. NONE
PakBus Address Read/
Write Options: 1 – 4094
A PakBus Address should be assigned to the camera for PakBus
Communication. 55
PakBus Destination
Address Read/
Write Options: 1 – 4094
This is the PakBus address of the destination device where the
image files will be transmitted. The device is normally a
Campbell Scientific datalogger. 1
Extra Communication
Delay Read/
Write Options: 0 – 10 Seconds
Additional Delays can be added for PakBus networks with long
propagation delays. 1
RS-485 BAUD rate Read/
Write Options: 230400, 115200, 76800, 57600, 38400, 28800, 19200,
9600, 1200 115,200
RS-232 BAUD rate Read/
Write Options: 230400, 115200, 76800, 57600, 38400, 28800, 19200,
9600, 1200 115,200
CS I/O SDC
ADDRESS Read/
Write Options: 7 or 8
If other CSDC devices are connected to the same CS I/O port,
each device must have its own address. 8
Compression Level Read/
Write Options: Very High, High, Medium, Low, None
This option selects the amount of compression to be applied to the
JPG files. Higher compression levels result in smaller files but
the images will lose subtle details. Selecting none will produce a
large sized (480Kb) Lossless image. High
Start Minute Read/
Write Options: 0-1339
If the camera is in a Self-Timed Mode, this parameter allows a
start time from Midnight to be selected. 0
Stop Minute Read/
Write Options: 0-1440
If the camera is in a Self-Timed Mode, this parameter allows a
stop time from Midnight to be selected. 1440
Self-Timed Interval Read/
Write Options: 0-1440
If this parameter is non–zero then the camera will automatically
wake itself up and acquire images based on the interval entered. 0
17