Campbell Scientific CC640 Digital Camera - Manual (Page 44)

CC640 Digital Camera
FIGURE 18. The Back of the 18543 Enclosure Showing the
Lockable Hasp
15.2 Camera Mounting Holes
For flexibility, the camera is equipped with 2 different sets of mounting holes
(Figure 19). There are three ¼”-20 threaded mounting holes along the center
of the camera that are spaced 2.0” (50.8mm) apart. The setscrews need to be
removed with a 1/8” hex Allen key to use the ¼”-20 threaded mounting holes.
At least two of the ¼”-20 threaded holes are required for mounting the camera.
The camera is also equipped with four #4-40 threaded mounting holes that are
spaced 1.5” x 5.0” (38 mm x 127 mm) apart.
Important: The fasteners used for mounting must be 0.375 inches (9.5 mm)
or shorter. Using longer fasteners can cause damage to the camera by
protruding too far into the camera and damaging the circuit boards. It is
recommended to use only the fasteners provided with the camera.
FIGURE 19. Mounting Hole
38