Campbell Scientific CVS4200 / BVS4300 Stationary Samplers - Manual (Page 49)

CVS4200 / BVS4300 Stationary Samplers
Press a number key (0-9) to replace any
existing number and advance the flashing
prompt to the next digit to change. Replace
digits as required, then press ENTER.
The display will echo the last entry with
<ENTERED>.
Any wrong entries will require re-entry. If
ENTER has not been pressed, reposition the
prompt over the incorrect digit and replace
it. After ENTER has been pressed, the entire
entry must be redone from the beginning
(press SET).
The controller has now been given a new
value for START DELAY. The new values
reside in the NEW ENTRIES area of the
controller memory. To make these changes
active, press the RESTART key; press it
again to confirm your choice. The controller
will then wait until the required pulses have
been received before starting its sampling
program.
Summary of Sequence:
SET, START DELAY, ARROW(S), ENTER, #######, ENTER,
RESTART, RESTART.
7.6.4.4 START DELAY using 4-20mA Input
The following sequence of entries are made
on the Touchpad to create a future starting
time for the operation of the Sampler. The
ACTIVE SETTINGS are not being altered.
1. Press the SET key.
2. Press the START DELAY key.
3. Press an ARROW key. Continue until 4-
20mA Input is shown on the display.
41