Campbell Scientific SDM-IO16 16-Channel Input/Output Expansion Module - Manual (Page 3)

IMPORTANT – Please Read First
Datalogger Instruction 188 – Software Requirements
1. PC208W Datalogger Support Software
PC208W support of SDM-IO16 Instruction 188 requires
replacement of some PC208W files NOTE
Datalogger Instruction 188 for the SDM-IO16 was developed after the release
of PC208W version 3.3. Campbell Scientific will not release another version of
PC208W but instead will offer the next generation datalogger support software
which is LoggerNet. Instruction 188 is supported in LoggerNet version 2.1 and
later.
A special patch to PC208W version 3.3 is available from our website to give
support for Instruction P188. If you do not already have version 3.3, follow
steps 1 to 3 below, otherwise start at step 4. You must have PC208W version
3.0 or later to complete this upgrade.
1. Go to Campbell Scientific website www.campbellsci.com/resource.html.
2. In section “Product Upgrades”, click on link 3.3 to link to the patch for
PC208W/P.
3. Follow instructions for On-line Upgrades. An email will be sent to you
with a link to the required files for the patch. The patch will upgrade
PC208W to version 3.3.
4. Next, download file ed16update.exe from our ftp site,
ftp://ftp.campbellsci.com/pub/csl/outgoing/ to a location of your choice.
Open the self-extracting file. The default directory is C:\PC208W\BIN
which will be correct for almost all PC208W installations. (If your original
installation was to some different disk or directory, amend the path as
required, and install to the appropriate \BIN directory.) Select other
options using the radio buttons.
This upgrade also includes support for Campbell Scientific’s
CS616 sensor. NOTE
5. Follow the instructions below to upgrade your Datalogger Operating
System.