Pro-Lite PL-XPSB4014 (shown) - Manual (Page 24)

17
I program and run my message, but it shows characters I don't want.
This is usually a programming error. Edit your message and use the arrow keys
(left and right arrows) to locate the unwanted characters. When you locate
them, press DEL to delete the unwanted characters. Please refer to page 1.
Will I lose my messages if I remove the power to the sign?
No, there is a built-in rechargeable battery in the sign. When you first purchase
the sign, you must program a short message and let the sign run for a minimum
of 72 hours in order for the battery to be fully charged.
After I unplug my sign, I lose the current TIME and DATE setting. Why?
The clock is dependent on the CPU clock, therefore when power is removed it
will reset the clock to 12:00. Please keep the sign powered at all times to keep
TIME and DATE accurate.
I forgot my PASSWORD. How do I get back in to erase it?
Stand 4' from the display. Using the wireless programmer, point to the top left
hand corner of the display and press and hold the ESC key. At the same time
remove the power from the left hand side of the display. Now press and hold
the ESC key again, and at the same time power up the display.
**You may need to repeat these steps several times. Remember to go back to
the SET mode to delete or set a new password.
Can I change the color of the TIME and DATE?
No, these colors are fixed.
Can I change the color of the TARGET variables?
No, these colors are fixed.
How do I make a word or sentence flash?
Please refer to page 5 on how to select a flashing font. Remember, the font you
select and begin to use will be saved in memory. If you decide you do not like
the font you used, you will have to select another font and re-type your mes-
sage.
How do I display lower-case letters?
Please refer to page 3.
How do I slow the speed of the display?
In most cases, you are standing too close to the display. The display is
designed to attract attention from 15' to 100' away. Stand back at least 20 feet
to view the speed of your message. If the speed is still too fast, simply use the
"DOWN" arrow key to set the speed slower. To increase the speed, press the
"UP" arrow key.