Allied Telesis AT-10408XP - Manual (Page 33)

AT-10408XP 10-Gigabit Ethernet Switch Installation Guide
33
Installing the Switch in a Rack
To install the AT-10408XP 10-Gigabit Ethernet Switch in a rack, perform
the following procedure:
1. If attached, remove the rubber feet using a flat-head screwdriver.
2. Install a bracket on one side of the switch using a Phillips screwdriver
and four of the rack-mount screws included with the switch, as shown
in Figure 10.
Figure 10. Attaching the Rack-Mount Bracket
3. Repeat step 2 to attach the remaining bracket to the other side of the
switch.
1211
AT-10408XP
10 Gigabit Ether
net Switch 1
XFP 2
XFP 3
XFP 4
XFP 5
XFP 6
XFP 7
XFP 8
XFP
STATUS FAULT MASTER
PSU1
PSU2
SD 10/100 LINK ACT
1000 L INK ACT
POR T ACTIV ITY
TER MINAL POR T
CLASS 1 LASER PROD UCT
10/100/1000B ase-T
10G LIN K ACT
BUSY NORMAL
FAULT