Allied Telesis AT-10408XP - Manual (Page 34)

Chapter 2: Installation
34
4. Mount the switch on a 19-inch rack using four screws (not included),
as shown in Figure 11
Figure 11. Mounting the Switch on the Rack
1212
AT-10408XP
10 Gigabit Eth
ernet Switch 1
XFP 2
XFP 3
XFP 4
XFP 5
XFP 6
XFP 7
XFP 8
XFP
STATUS FAULT MASTER
PSU1
PSU2
SD 10/100 L INK ACT
1000 LIN K ACT
PORT A CTIVIT Y
TER MINAL POR T
CLASS 1 LASER PROD UCT
10/100/1000B ase-T
10G LIN K ACT
BUSY NOR MAL
FAULT
Warning: To prevent electric shock, do not remove the cover.
No user-serviceable parts inside. This unit contains hazardous
voltages and should only be opened by a trained and qualified
technician. To avoid the possibility of electric shock, disconnect
electric power to the product before connecting or disconnecting
the LAN cables.
 E1
Warning: Do not work on equipment or cables during periods of
lightning activity.
 E2
Warning: Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.
 E3
Warning: Class I Equipment. This equipment must be earthed.
The power plug must be connected to a properly wired earth
ground socket outlet. An improperly wired socket outlet could
place hazardous voltages on accessible metal parts.
 E4
Pluggable Equipment. The socket outlet shall be installed near
the equipment and shall be easily accessible.
 E5
Caution: Air vents must not be blocked and must have free
access to the room ambient air for cooling.
 E6
Warning: Operating Temperature. This product is designed for a
maximum ambient temperature of 40° degrees C.
 E7