Allied Telesis AT-10408XP - Manual (Page 39)

AT-10408XP 10-Gigabit Ethernet Switch Installation Guide
39
Connecting the
10/100/1000
Base-T In-band
Management
Port
To connect the cable to the 10/100/1000Base-T in-band management
port, perform the following procedure:
1. Plug the cable into the port, as shown in Figure 16.
Figure 16. Connecting the 10/100/1000Base-T Cable
Note
For cabling specifications, refer to “In-band Management Port
Cabling” on page 49.
Connecting to the
RJ-45 Style
RS-232 Terminal
Port
To connect to the RJ-45 style RS-232 terminal port, perform the following
procedure:
1. Plug the cable into the port, as shown in Figure 17.
Figure 17. Connecting to the Terminal Port
7
XFP
8
XFP
STATUS
FAULT
MASTER
PSU1
PSU2
SD 10/100 LI NK ACT
1000 LI NK ACT TER MINAL POR
T
10/100/1000Base-
T
BUSY
NORM AL
FAULT
1217
7
XFP 8
XFP
STATUS
FAULT
MASTER
PSU1
PSU2
SD 10/100 LI NK ACT
1000 LI NK
ACT TER MINAL PO
RT
10/100/1000Base-
T
BUSY
NORMAL
FAULT
1218