Figure 13. inserting the xfp – Allied Telesis AT-10408XP User Manual
Page 37
Advertising
AT-10408XP 10-Gigabit Ethernet Switch Installation Guide
37
4. Slide the XFP transceiver into an XFP slot on the switch, as shown in
Figure 13. Inserting the XFP
5. Repeat steps 2 through 4 if you are installing other XFP transceivers.
Note
XFP transceivers are dust sensitive. When a fiber optic cable is not
installed, or when you store the XFP, always keep the plug in the
optical bores. When you do remove the plug, keep it for future use.
Note
Unnecessary removal and insertion of an XFP can lead to premature
failure.
For information about cabling for the XFP, consult the documentation
that was shipped with the XFP.
7
XFP
8
XFP
STATUS
FAULT
MASTER
PSU1
PSU2
SD
10/100 LI
NK
ACT
1000 LI
NK
ACT
TER
MINAL POR
T
10/100/1000Base-
T
BUSY
NORMAL
FAULT
1214
Advertising