Allied Telesis AT-S62 - Manual (Page 102)

Chapter 8: Port Mirroring
102 Section I: Basic Operations
Creating a Port Mirror
To create or delete a port mirror, perform the following procedure:
1. From the Home Page, select Configuration.
2. From the Configuration menu, select Layer 1.
3. Select the Port Mirroring tab.
The Port Mirroring tab is shown in Figure 24.
Figure 24. Port Mirroring Tab (Configuration)
This tab displays any port mirror already existing on the switch. The
columns are defined below:
Mirror to Port
This is the destination port where the traffic will be copied to and where
the network analyzer will be located. There can be only one
destination port. A 0 (zero) in this column indicates there is no port
mirror on the switch.
Ingress Port(s)
This column lists the source ports whose ingress traffic is mirrored to
the destination port.
Egress Port(s)
This column lists the source ports whose egress traffic is mirrored to
the destination port.