Allied Telesis AT-S62 - Manual (Page 215)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 215
Configuring the SNMPv3 View Table
You can create, delete, and modify an SNMPv3 View Table entry. See the
following procedures:
ˆ “Creating a View Table Entry” on page 215
ˆ “Deleting a View Table Entry” on page 218
ˆ “Modifying a View Table Entry” on page 219
For reference information about the SNMPv3 View Table, see “Configuring
the SNMPv3 View Table” on page 215.
Creating a View
Table Entry
To create an entry in the SNMPv3 View Table entry, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab. The SNMP Tab is shown in Figure 58 on page
206.
4. In the SNMPv3 section of the page, click the circle next to Configure
View Table. Then click Configure at the bottom of the page. The
SNMPv3 View Table Page is shown in Figure 62.
Figure 62. SNMPv3 View Table Page