Allied Telesis AT-S62 - Manual (Page 72)

Chapter 5: Port Parameters
72 Section I: Basic Operations
Configuring Port Parameters
To configure the parameter settings for a port on the switch, perform the
following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select the Layer 1 option.
3. Select the Port Settings tab.
The Port Settings tab is shown in Figure 15.
Figure 15. Port Settings Tab (Configuration)
4. Click a port in the graphical switch image to configure. The selected
port turns white. You can configure more than one port at a time. (To
deselect a port, click it again.)
5. Click Modify. To configure all of the base ports (not including any
expansion ports), click Modify All.
The Port Configuration page is shown Figure 16.