Allied Telesis AT-S62 User Manual
Page 12
12
Preface
This guide describes how to configure an AT-8500 Series switch using
the AT-S62 command line interface. The commands are grouped by
topic into the following chapters:
❑ Chapter 1: Starting a Command Line Management Session on
❑ Chapter 2: Basic Command Line Commands on page 20
❑ Chapter 3: Enhanced Stacking Commands on page 30
❑ Chapter 4: Basic Switch Commands on page 36
❑ Chapter 5: Simple Network Time Protocol (SNTP) Commands on
❑ Chapter 6: SNMPv1 and SNMPv2 Community Strings and Trap
❑ Chapter 7: SNMPv3 Commands on page 99
❑ Chapter 8: Port Parameter Commands on page 157
❑ Chapter 9: MAC Address Table Commands on page 177
❑ Chapter 10: Port Trunking Commands on page 186
❑ Chapter 11: Networking Stack Commands on page 194
❑ Chapter 12: LACP Commands on page 204
❑ Chapter 13: Port Mirroring Commands on page 219