Allied Telesis AT-S62 - Manual (Page 404)

Chapter 26: RSTP Commands
404
SHOW RSTP
Syntax
show rstp [portconfig=port|portstate=port]
Parameters
portconfig Displays the RSTP port settings. You can specify more
than one port at a time.
portstate Displays the RSTP port status. You can specify more
than one port at a time.
Description
You can use this command to display the RSTP parameter settings.
Values are displayed for the following parameters:
❑ RSTP status
❑ Bridge identifier
❑ Bridge priority
❑ Hello time
❑ Maximum aging
❑ Forwarding delay
You can also use this command to view the following RSTP parameter
settings for a switch port:
❑ Port cost
❑ Port priority
❑ Edge and point-to-point status
Examples
The following command displays the bridge’s RSTP settings:
show rstp
The following command displays the RSTP port settings for ports 1 to 4:
show rstp portconfig=1-4