Allied Telesis AT-S62 - Manual (Page 192)

Chapter 10: Port Trunking Commands
192
SET SWITCH TRUNK
Syntax
set switch trunk=name
select=[macsrc|macdest|macboth|ipsrc|ipdest|
ipboth]
Parameters
trunk Specifies the name of the port trunk.
select Specifies the load distribution method. Options are:
macsrc Source MAC address.
macdest Destination MAC address.
macboth Source address/destination MAC
address.
ipsrc Source IP address.
ipdest Destination IP address.
ipboth Source address/destination IP
address.
Description
This command changes the load distribution method of an existing port
trunk. To view the trunks on a switch, refer to SHOW SWITCH TRUNK on
page 193.
Example
The following command changes the load distribution method of a
trunk named “Load11” to destination IP address:
set switch trunk=Load11 select=ipdest