Allied Telesis AT-S60 - Manual (Page 676)

Chapter 39: STP, RSTP, and MSTP
Section VI: Web Browser Management 676
Configuring and Modifying RSTP
To configure and modify RSTP, perform the following procedure:
Caution
The bridge provides default RSTP parameters that are adequate for
most networks. Changing them without prior experience and an
understanding of how RSTP works might have a negative effect on
your network. Consult the IEEE 802.1w standard before changing
any of the RSTP parameters.
1. Follow the steps in the procedure described in Enabling STP, RSTP, or
MSTP on page 670.
2. On the Spanning Tree Tab, click Configure.
3. Select RSTP as your active protocol version.
The Configure RSTP Parameters Tab is displayed as shown in
Figure 233.