Allied Telesis AT-S60 - Manual (Page 71)

AT-S60 Management Software User’s Guide
Section I: Basic Features 71
Pinging a Remote System
You can instruct the switch to ping a remote device on your network.
This procedure is useful in determining whether a valid link exists
between the switch and another device.
To ping a network device, perform the following procedure:
1. From the Main Menu, type 4 to select Administration Menu.
The Administration Menu is shown in Figure 4 on page 48.
2. From the Administration Menu, type P to select Ping a Remote
System.
The following prompt is displayed:
Please enter an IP address ->
3. Enter the IP address of the end node you want the switch to ping in
the following format: xxx.xxx.xxx.xxx.
The results of the ping command are displayed on the screen. To
stop the ping, press any key.