Allied Telesis AT-S60 - Manual (Page 702)

Chapter 40: SNMPv3 Protocol
Section VI: Web Browser Management 702
5. To save your changes, return to the General Tab and click Save
Changes.
Modifying a
User Table
Entry
To modify an entry SNMPv3 User Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 192 on page 584.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 195 on page 596.
3. In the SNMPv3 section of the page, click the circle next to Configure
User Table. Then click Configure.
The SNMPv3 User Table Page is shown in Figure 243 on page 699.
4. To modify an SNMPv3 User Table entry, click the circle next to the
SNMPv3 user that you want to change. Then click Modify.
The Modify SNMPv3 User Page is shown in Figure 245.
Figure 245 Modify SNMPv3 User Page
5. In the Authentication Protocol field, enter an authentication protocol.
This is an optional parameter.