Spektrum DX6i - Manual (Page 127)

127 SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
Press the roller to deselect the master channel then rotate the roller to select the slave channel.
Press the roller to access the slave channel selection.
Rotate the roller to select the desired slave channel.
• THRO: Throttle
• AILE:
Aileron
• ELEV: Elevator
• RUDD: Rudder
• GYRO: Gyro
• PITC:
Pitch
SElECTING ThE MIXING vAlUES
Rotate the roller to highlight the desired rate and direction.
Reduce photo to 13.5%
MIX 1
THRO≥ THRO ACT
RATE D 0% U 0%
SW ON TRIM INH
List
Press the roller to access the rate value.
Using the roller, rotate to adjust the desired mixing values. Note that positive + and negative – values are available
and affect the direction of the slave servo travel.
After the desired value is programmed press the roller to deselect the value.