Spektrum DX6i - Manual (Page 30)

30 SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
lOw bATTERy AlARM
When the battery voltage drop below 4.3 volts an alarm will sound and the screen will flash.
TRAINER
The DX6i offers a Trainer function that allows the transmitter to operate as a master or slave. The trainer switch is
located on the back left of the transmitter. (The trainer switch is located on the back right on Mode 1 transmitters.)
MASteR
The transmitter can be used as a master but the slave transmitter must have the same programming (i.e. reverse,
travel adjust, dual rates, mixes, sub trims, etc.) as the master.
SlAvE MODE
When using the transmitter as a slave with another DX6i, it’s necessary to match all the programmable settings (i.e.
reverse, travel adjust, etc.).
PROGRAMMING USING ThE ROllER
The roller is used to access all programming functions.
• Pressing and releasing the roller accesses/ enters the selected function
• Rolling the roller changes values or selections
TO ACCESS ThE MAIN SCREEN:
Anytime the transmitter is turned on, the main screen will appear.
Reduce photo to 13.5%
MUSTANG
5.0V
MDL6
DN06:00
TO RETURN TO ThE MAIN SCREEN:
From the ADJUST LIST or SETUP LIST screens, pressing and holding the roller for more than three seconds then
releasing the roller will return the display to the main screen.
TO RETURN TO ThE lIST OR SETUP SCREEN:
From the any program function screens, pressing and holding the roller for more than three seconds then releasing
the roller will return the display to the LIST of SETUP screen.