Spektrum DX6i - Manual (Page 16)

16 SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
SERvO INSTAllATION
In gas- and glow-powered aircraft where vibration is present, the servos should be mounted using the supplied
rubber grommets and bushings. Do not over-tighten the mounting screws. The diagram will assist you in properly
mounting the grommets and bushings. In electric and non-powered aircraft, there are many acceptable methods
for mounting the servo, including servo tape and even glue. See the information included with your aircraft for the
recommendation for installing servo(s) in your aircraft.
Servo Lead w/Connector
Servo Arm Retaining Screw
Servo Arm/Horn
Servo Output Shaft
Servo Eyelet
Rubber Grommets
Servo Mounting Flange
Servo Case
Servo Mounting Flange
Rubber Grommets