HID DTC1000/4000/4500 User Guide LINUX & MAC - Manual (Page 20)

© 2011 HID Global Corporation All rights reserved
DTC1000/DTC4000/DTC4500 CUPS Driver User Guide - LINUX (L001452, Rev 1.2) 20
Section 4: Printer Maintenance
Performing a Ribbon Sensor Calibration
Step Procedure
1 Remove all cards from the Card Hopper and close the Hopper door.
2 Open the Front Cover, remove the Ribbon Cartridge and close the Printer’s
front cover.
3 From a terminal window enter:
lpr - P DTC4000 “/usr/share/fargo/DTC4000/CalibrateRibbon.prn”
4 When completed, the Printer will beep twice.
Performing a Lamination Sensor Calibration
This procedure applies to strictly to the DTC4500 Printer.
Step Description
1 Ensure that the Cartridges are out of the Laminator.
2 Ensure the Laminator cover is closed.
3 From a terminal window enter:
lpr - P DTC4500 “/usr/share/fargo/DTC4500/CalibrateLamination.prn”
4 When completed, the Printer will beep twice.