Reviewing the f-panel options, Reviewing the lamination options – HID DTC1000/4000/4500 User Guide LINUX & MAC User Manual
Page 45
© 2011 HID Global Corporation
All rights reserved
Fargo DTC1000/DTC4000/DTC4500 CUPS Driver User Guide - LINUX (L001452, Rev 1.2)
45
Reviewing the F-Panel Options
F-Panel cards must be printed on the command line.
Command Line Usage
CUPS Options
Description
FpanelFrontFilename =
X
n/a
Sets the filename for the F-panelfront.
The F-panelfront will only be printed if
an explicit file name is specified.
FpanelBackFilename =
X
n/a
Sets the filename for the F-panelback.
The F-panelback will only be printed if
an explicit file name is specified.
FPanelInvertImage =
true/ false
n/a
Inverts the F-panel image
Reviewing the Lamination Options
To increase lamination adhesion, overlay should not be applied. Ribbon with an overlay
panel (i.e. YMCKO, YMCKO_HP, YMCKOK, YMCFKO, YMCFKOK, KO, BO), by default will
apply the overlay, to change this, select Print Only (No Overlay) from Overlay and Print
options. (Note: These options apply to the DTC4500 only.)