Alliance Laundry Systems Stacked Clothes Dryer - Manual (Page 16)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
510975 14
Installing the Dryer
Step 1: Position and Level the Dryer Unit
For further assistance, refer to section on Location
Requirements.
Install dryer before washer. This allows room for
attaching exhaust duct.
Install the four rubber cups found in the accessories
bag.
Place the dryer in position, and adjust the legs until the
dryer is level from side to side and front to back.
Figure 5
Step 2: Connect Dryer Unit Exhaust
System
For further assistance, refer to sections on Location
Requirements and Dryer Exhaust Requirements.
● DO NOT use plastic or thin foil ducting.
● Locate dryer so exhaust duct is as short as
possible.
● Be certain old ducts are cleaned before installing
your new dryer.
● Use 4" (10.2 cm) diameter rigid or flexible metal
duct.
● The male end of each section of duct must point
away from the dryer.
● Use as few elbows as possible.
● Use duct tape or pop-rivets on all duct joints.
● Ductwork that runs through unheated areas must
be insulated to help reduce condensation and lint
build-up on pipe walls.
● Install backdraft dampers in multi-dryer
installations.
● Failure to exhaust dryer properly will void
warranty.
.
Figure 6
NOTE: Venting materials are not supplied with the
dryer (obtain locally).
D690I
1 Dryer Base
2 Level
3 Leveling Leg
4 Rubber Cup
D690I
1
3
2
4
A clothes dryer produces combustible
lint. To reduce the risk of fire and
combustion gas accumulation the dryer
MUST be exhausted to the outdoors.
W116
WARNING
D354I D356I
DO DON’T