Warning, Electrical requirements – Alliance Laundry Systems Stacked Clothes Dryer User Manual
Page 31
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
29
510975
Electrical Requirements
(Gas Dryers)
(120 Volt, 60 Hertz, with 3-Prong Grounding Plug)
NOTE: The wiring diagram is located behind the
control panel, inside the control cabinet.
●
Each dryer is designed to be operated on a
separate branch, polarized, three-wire, effectively
grounded, 120 Volt, 60 Hertz, AC (alternating
current) circuit protected by a 15 ampere fuse,
equivalent fusetron or circuit breaker.
●
The three-prong grounding plug on the power
cord should be plugged directly into a polarized
three-slot effectively grounded receptacle rated
120 Volts AC (alternating current) 15 Amps.
Refer to Figure 19 to determine correct polarity
of the wall receptacle.
NOTE: A qualified electrician should check the
polarity of the wall receptacles. If a voltage reading
is measured other than that illustrated, the
qualified electrician should correct the problem.
●
DO NOT OPERATE OTHER APPLIANCES
ON THE SAME CIRCUIT WHEN THIS
APPLIANCE IS OPERATING. DO NOT
OVERLOAD CIRCUITS! Refer to Figure 18.
.
Figure 18
To reduce the risk of fire, electric shock or
personal injury, all wiring and grounding
MUST conform with the latest edition of
the National Electrical Code ANSI/NFPA
70 or the Canadian Electrical Code, CSA
C22.1, and such local regulations as
might apply. It is the customer’s
responsibility to have the wiring and
fuses checked by a qualified electrician to
make sure the laundry room has adequate
electrical power to operate the dryer.
W035
WARNING
This dryer is equipped with a three-prong
(grounding) plug for your protection
against shock hazard and should be
plugged directly into a properly grounded
three-prong receptacle. Do not cut or
remove the grounding prong from this
plug.
W036
WARNING
D009I
DO NOT
OVERLOAD
CIRCUITS
To reduce the risk of an electric shock or
fire, DO NOT use an extension cord or an
adapter to connect the dryer unit to the
electrical power source.
W152
WARNING