Alliance Laundry Systems Stacked Clothes Dryer - Manual (Page 36)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
510975 34
Dryer Exhaust Requirements
Exhaust System Materials
Exhaust system materials are not supplied with the
dryer unit.
Exhaust duct must be four inches (10.2 cm) in
diameter having no obstructions. Rigid metal duct is
recommended. Non-combustible flexible metal duct is
acceptable. Do not use plastic or thin foil ducting,
because it contributes to poor drying performance and
collects lint, which can lead to a fire hazard.
Never install flexible duct in concealed spaces, such as
a wall or ceiling.
DO NOT use sheet metal screws on exhaust pipe joints
or other fastening means which extend into the duct
that could catch lint and reduce the efficiency of the
exhaust system. Secure all duct joints with duct tape or
pop-rivets.
NOTE: Kits described above are optional exhaust
system materials available at extra cost.
.
Figure 22
A clothes dryer produces combustible
lint. To reduce the risk of fire and
combustion gas accumulation the dryer
MUST be exhausted to the outdoors.
W116
This gas appliance contains or produces
a chemical or chemicals which can cause
death or serious illness and which are
known to the State of California to cause
cancer, birth defects, or other
reproductive harm. To reduce the risk
from substances in the fuel or from fuel
combustion, make sure this appliance is
installed, operated, and maintained
according to the instructions in this
manual.
W115
To reduce the risk of fire and the
accumulation of combustion gases, DO
NOT exhaust dryer air into a window well,
gas vent, chimney or enclosed,
unventilated area, such as an attic, wall,
ceiling, crawl space under a building or
concealed space of a building.
W045
To reduce the risk of fire, DO NOT use
plastic or thin foil ducting to exhaust the
dryer.
W354
WARNING
Description Kit P/N
May Be
Obtained
Locally
Exhaust Duct (4" Dia.) Not Available Yes
Flexible Metal Duct
(4" Dia.) 521P3 Yes
Weather Hoods, with
hinged dampers (4") Not Available Yes
Directional Exhaust
Kit 528P3 No
Tape Not Available Yes
DO DON’T
D354I D356I