AMX NetLinx Integrated Controllers NI-3000 - Manual (Page 11)

Introduction
5 NetLinx Integrated Controllers
NI-3000 Specifications
The front LEDs (FIG. 3) are grouped by control type and are numbered according to their
corresponding port (connector) numbers on the rear of the unit. The back of the this unit contains
RS-232/422/485, Relay, IR/Serial and I/O connectors. In addition, this unit provides an ID
pushbutton, AXlink LED, and other related connectors. FIG. 4 shows the front and rear of the
NI-3000.
NI-2000 Specifications (Cont.)
Ethernet Link/Activity LED • LEDs show communication activity, connections, speeds, and mode
information:
SPD-speed - Yellow LED lights On when the connection speed is 100 Mbps
and turns Off when the speed is 10 Mbps.
L/A-link/activity - Green LED lights On when the Ethernet cables are
connected/terminated correctly and blinks when receiving Ethernet data
packets.
AXlink LED • One green LED indicates the state of the AXlink connector port.
• Normal AXlink activity = 1 blink/second
• Abnormal AXLink activity = cycle of 3 consecutive blinks and then Off
AXlink port • 4-pin 3.5 mm mini-Phoenix (male) connector provides data and power to
external control devices.
Power port • 2-pin 3.5 mm mini-Phoenix (male) connector
Included Accessories: • 2 CC-NIRC IR Emitters (FG10-000-11)
• Installation Kit (KA2105-01):
One 8-pin Relay Common Strip (41-2105-01)
Four rack mount screws (80-0186)
Four washers (80-0342)
• One 8-pin 3.5 mm mini-Phoenix (female) Relay connector (41-5083)
• One 6-pin 3.5 mm mini-Phoenix (female) I/O connector (41-5063)
• One 4-pin 3.5 mm mini-Phoenix (female) AXlink connector (41-5047)
• One 2-pin 3.5 mm mini-Phoenix (female) PWR connector (41-5025)
• Removable rack ears. Allows for tabletop and under-counter mountings
Optional Accessories: • 2 Pin Black Male Phoenix Connector (3.5mm) (41-5026)
• CC-NIRC IR cables (FG10-000-11)
• CC-NSER IR/Serial cables (FG10-007-10)
• CSB Cable Support Bracket (FG517)
• NCK, NetLinx Connector Kit (FG2902)
• NI-2000 Quick Start Guide (93-2105-01)
• PSN2.8 12 VDC power supply (FG423-17)
• PSN6.5 12 VDC power supply (FG423-41)
• STS, Serial To Screw Terminal (FG959)
• Upgrade Compact Flash (factory programmed with firmware):
NXA-CFNI64M - 64 MB compact flash card (FG2116-31)
NXA-CFNI128M - 128 MB compact flash card (FG2116-32)
NXA-CFNI256M - 256 MB compact flash card (FG2116-33)
NXA-CFNI512M - 512 MB compact flash card (FG2116-34)
NXA-CFNI1G - 1 GB compact flash card (FG2116-35)