AMX NetLinx Integrated Controllers NI-3000 - Manual (Page 112)

NetLinx Security with a Terminal Connection
106 NetLinx Integrated Controllers
Help menu
Type help at the prompt in the Telnet session to display the following help topics:
Help Menu Options
Command Description
----- Help ----- <D:P:S> (Extended diag messages are OFF)
<D:P:S> : Device:Port:System. If omitted, assumes Master.
? or Help Displays this list.
DATE Displays the current date.
DEVICE HOLDOFF ON|OFF Sets the Master to holdoff devices (i.e. does not allow them to report
ONLINE) until the NetLinx program has completed executing the
DEFINE_START
section.
If set to ON, any messages to devices in DEFINE_START will be lost;
however, this prevents incoming messages being lost in the Master
upon startup. When DEVICE_HOLDOFF is ON, you must use ONLINE
events to trigger device startup SEND_COMMANDs.
By default, DEVICE HOLDOFF is OFF to maintain compatibility with
Axcess systems where f devices are initialized in DEFINE_START.
DEVICE STATUS <D:P:S> Provides information about the specified device.
DNS LIST <D:P:S> Displays the DNS configuration of a device.
DISK FREE Displays the amount of free space on the disk.
GET DEVICE HOLDOFF Displays the state of the device holdoff setting in the Master
GET IP <D:P:S> Displays the IP configuration of a device.
HELP SECURITY Displays security related commands.
IP STATUS Provides information about NetLinx IP Connections.
MEM Shows size of the largest block of available memory.
MSG ON|OFF Enables/Disables extended diagnostic messages.
OFF [D:P:S or NAME,CHAN] Turns off the specified channel.
ON [D:P:S or NAME,CHAN] Turns on the specified channel.
PASS [D:P:S or NAME] Puts the Session in pass mode to the specified device.
• Mode is exited by ++ ESC ESC.
• Display Format is set by ++ ESC n
If n is A, format = ASCII
If n is D, format = Decimal
If n is H, format = Hex
PING [ADDRESS] Pings an address (IP or URL).
Specify an option for reverse lookup.
PROGRAM INFO Displays a list of program modules loaded.
PULSE [D:P:S or NAME,CHAN] Pulses the specified channel.
REBOOT <D:P:S> Reboots the device.
RELEASE DHCP Releases the current DHCP lease.
ROUTE MODE DIRECT|NORMAL Set the Master-Master route mode.
SEND_COMMAND D:P:S or
NAME,COMMAND
Sends the specified command to the device.The Command uses
NetLinx string syntax.
• Ex: send_command 1:1:1,"'This is a test',13,10"
• Ex: send_command RS232_1,"'This is a test',13,10"
SEND_STRING D:P:S or
NAME,STRING
Sends the specified string to the device.
SET DATE Set the current date.