Sony PCGA-DVD51 - Manual (Page 11)

11
6
Select “SCSI controllers” from “Hardware types”
and then click [Next].
7
Click [Have Disk].
8
Check that the supplied installation disk is in the
floppy disk drive, ensure that “Copy manufacturer’s
files from” is “A:\” and then click [OK].
9
Ensure that “Sony 16Bit ATAPI PC Card” appears
on the “Model” item and then click [Next].
10
Click [Next].
11
Click [Finish].
In step 12, confirm the system settings.
12
Confirm the system settings.
To confirm the system settings
When the DVD-ROM drive is connected to the
computer after installing the driver, click the Start
button, select [Settings] , click [Control Panel],
double-click [System], click [Device Manager] and
then double-click [SCSI controllers]. If “PCMCIA
ATA Card” appears in the “System Properties”
window, you must perform the following procedure:
1 Click “PCMCIA ATA Card” and then click
[Remove].
The “Confirm” window appears.
2 Click [OK].
3 Remove the DVD-ROM drive from the
computer.
4 Reconnect the DVD-ROM drive to the
computer.
5 Ensure that “SCSI controllers” shows “Sony
16Bit ATAPI PC Card” in the “System
Properties” window.
Note
When confirming the
system settings, connect
the PC card of the DVD-
ROM drive without the
supplied AC adapter.