Warning, For the customers in europe – Sony DPP-FP97 User Manual

Page 2

Advertising
background image

2

GB

WARNING

To reduce fire or shock hazard, do not
expose the unit to rain or moisture.

For the customers purchasing
the DPP-FP97 in the U.S.A.

CAUTION

You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment.

If you have any questions about this product, you may
call:
Sony Customer Information Services Center
1-800-222-SONY (7669)

The number below is for the FCC related matters
only.

Regulatory Information

Note:

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by
one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and

receiver.

– Connect the equipment into an outlet on a circuit

different from that to which the receiver is
connected.

– Consult the dealer or an experienced radio/TV

technician for help.

For the Customers in Europe

This product has been tested and found compliant
with the limits set out in the EMC Directive for using
connection cables shorter than 3 meters (9.8 feet).

Attention

The electromagnetic fields at the specific frequencies
may influence the picture of this digital photo printer.

Notice

If static electricity or electromagnetism causes data
transfer to discontinue midway (fail), restart the
application or disconnect and connect the
communication cable (USB, etc) again.

Notice for the customers in the
countries applying EU Directives

The manufacturer of this product is Sony
Corporation, 1-7-1 Konan Minato-ku Tokyo,
108-0075 Japan.
The Authorized Representative for EMC and product
safety is Sony Deutschland GmbH, Hedelfinger
Strasse 61, 70327 Stuttgart, Germany.
For any service or guarantee matters, please refer to
the addresses given in separate service or guarantee
documents.

Declaration of Conformity

Trade Name:

SONY

Model No.:

DPP-FP97

Responsible Party: Sony Electronics Inc.
Address:

16530 Via Esprillo, San Diego,
CA 92127 U.S.A.

Telephone No.:

858-942-2230

This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.

Advertising