Sony DPP-FP97 - Manual (Page 51)

51 GB
Print
ing
from
a
Blue
too
th-c
o
m
p
lian
t de
vi
ce
To select the printer from a Bluetooth-
compliant device, select “Sony DPP-FP97 ##.”
(“##” stands for the two figures from the right
of the address displayed in the LCD screen.)
When input of Passkey* is required
Input “0000.” You cannot change the Passkey
with the printer.
* A Passkey is often referred to as a “pass code” or
“PIN code.”
1
Insert a memory card into the
appropriate memory card slot of the
printer.
Insert a memory card that you want to
save an image to be transferred only.
The Bluetooth saving mode window is
displayed. On upper left on the screen,
is displayed.
2
Transfer an image from the
Bluetooth-compliant mobile phone,
or other device.
Perform the similar procedures when you
print an image. For details, refer to the
operating instructions of the Bluetooth-
compliant device you are using.
The image transferred is saved in the
memory card.
Notes
• You cannot transfer an image to the internal
memory of a digital photo printer.
• Do not use the DPPA-BT1 outside the area you
purchased it. Depending on the areas, the use of
this product may violate the local radio wave
regulations and may be subject to its penalty.
• The communication distance of the product may
vary depending on the obstacles (a human body,
metal object, or wall) between the product and the
mobile phone or other device.
• The sensitivity of the Bluetooth communication
may be affected in the following conditions:
– When there is an obstacle between the product
and the mobile phone or other product such as a
human body, metal object, or a wall.
– Where a wireless LAN is established or a
microwave oven is being used near-by, or other
electromagnetic waves are emitted.
• Since a Bluetooth device and a wireless LAN
(IEEE802.11b/g) device use the same frequency
ranges, wave interference may occur when the
product is used near a device equipped with a
wireless LAN. This may cause deterioration in the
communication speed and connection conditions.
If this occurs, take the following measures:
– Keep a distance of at the least 10 m from a
wireless LAN device when you connect the
product to a mobile phone.
– Turn off the wireless LAN device in case you
want to use the product closer than 10 m from
the wireless LAN device.
• We cannot guarantee that this product works with
all devices enabled with Bluetooth wireless
technology.
• Sony cannot assume any responsibility for any
information leakage that may be caused in
Bluetooth communications.
• Sony cannot accept responsibilities for any failure
to satisfy the protection requirements resulting
from a non-recommended modification or use of
the product.
P Caution
• Radio waves from a Bluetooth device may
adversely affect the operation of electrical and
medical devices, and could lead to accidents due to
malfunctions. Make sure to turn off the product
and mobile phone and do not use this product in
the following places:
– Inside medical facilities, trains, airplanes, gas
stations or other places that may emit flammable
gas.
– near automatic doors or fire alarms or other
automatically controlled devices.
• Keep this product at least 22 cm away from cardiac
pacemakers. Radio waves from this product may
adversely affect the operation of cardiac
pacemakers.
• Do not disassemble or modify this product. Doing
so could result in injury, electric shock, or fire.
Transferring an image to a
memory card