Sony MXD-D400 - Manual (Page 32)

32 GB
Therefore, when an MD recorded using the
Group Function is loaded on a deck that does not
support the Group Function or on this deck with
the Group Function turned off, the above
character string is displayed in its entirety as the
disc title.
Note that if you rewrite this character
string by mistake using the Name
Function, you may be unable to use the
Group Function of that MD.
*
* “GROUP ON” flashes. To use the Group Function
again, first perform the procedure for “Releasing all
groups on an MD” (page 36) and release the
registrations of all tracks on the MD.
If “Group Full!” appears during
operation
You cannot start recording because there is
insufficient character space for group
management. Delete unnecessary characters
(disc title or track titles) until group recording is
possible (page 34).
Notes
• The Group Function setting is stored even if you
eject the MD or turn off the deck.
• When the Group Function is on, tracks which are not
registered to a group are not displayed and cannot be
played.
• You cannot change the group order.
• The new group is added after any existing groups
with tracks registered.
• When you newly record a track into an existing
group, the new track is added after any existing
tracks in the group.
• Up to 99 groups can be registered on a single MD.
• When you newly record a track into an existing
group, the track numbers following the newly
recorded track may change when the Group Function
is turned off.
• If you load a disc with group management
information written in other than the proper format,
“GROUP ON” flashes. In this case you cannot use
the Group Function.
You can create titles for your recorded MDs,
tracks, and groups as follows.
After recording
Use Name Function.
You can input a total of approximately
1,700 characters for the disc title, track titles and
group titles on a single MD.
When labeling an MD recorded using the
Group Function, be sure to label the disc
with the Group Function on so as not to
rewrite the group management
information by mistake.
For details on the group management
information, see “How is group information
recorded?” on page 31.
Labering using the buttons on the
remote
1
Set to MD in CD MD select switch.
Labeling an MD/group/
track
— Name Function
2,3
1
4
6
CLEAR
m/M
./>
GROUP
ON/OFF
ALBUM/
GROUP
+/–
SCROLL