Battery installation & charging – AT&T E1814B User Manual

Page 10

Advertising
background image

7

Getting started

1. Plug the small end of

the smaller power adapter

into the jack on the under-

side of the charger, then

route the cord through the

slot as shown.

BATTERY LOW

10:08

AM

02/14

NEEDS RECHARGING

then

Battery installation & charging

After installing the battery, you may be able to make or receive short calls. For

best performance, place the handset in the telephone base or charger to charge

for 16 hours before use.
You can keep the battery charged by returning the handset to the telephone base

or charger after use. When the battery is fully depleted, a recharge takes about 12

hours. The average talk time on a fully charged battery is about five hours, and the

standby time is approximately six days. Actual battery life depends on usage con-

ditions and age of battery.

3. Insert the plug as indicat-

ed. Be sure to securely insert

the plug, making sure that it

matches the color-coded label

inside the battery compart-

ment.

6. You may be able to make or receive

short calls. For best performance, place the

handset in the telephone base or charger to

charge for at least 16 hours before first use.

Caution: Use only the supplied rechargeable battery, replacement battery 2422 (SKU 23402, part

number 89-0047-00-00) or equivalent.

To order a replacement battery, visit our

website at www.telephones.att.com or call 1 (800) 222-3111. In

Canada dial 1 (866) 288-4268.

To replace the battery,

press in and downward

on the tab of the bat-

tery compartment to

open the battery com-

partment cover. Lift

out the old battery

and disconnect it from

the handset. Follow

the instructions on

this page to install and

charge the new battery.

5. Slide the bat-

tery compart-

ment cover up

until it clicks.

Battery low indicator

Return the handset to the

telephone base or charger

to recharge when this sym-

bol flashes and the handset

beeps or when the hand-

set screen displays NEEDS

RECHARGING.

4. Place the bat-

tery and wires

inside the com-

partment.

2. Plug the large

end of the smaller

power adapter into

an electrical outlet

not controlled by a

wall switch.

NOTE: Under normal conditions, the

battery should last around one year. This

may vary depending on usage.

-- 1 --

Advertising