Message counter displays – AT&T E1814B User Manual
Page 42
39
Answering system operation
Message counter displays
The message counter usually displays the total
number of memos and incoming messages. See
the list below for explanations of other displays in
this counter.
Message counter displays
0
No
messages.
0
(flashing)
The clock needs to be set (page 34).
1-95
Total number of messages and memos,
or message number currently playing.
1-95
(flashing)
Total number of messages and memos.
The number flashes when there are new
(un-reviewed) messages.
If the telephone loses power, after power is
restored, the number in the message coun-
ter will flash to indicate the clock needs to
be set.
10-99
Current remote access code while setting
(page 36).
1-99
(counting)
Elapsed time while recording a memo
(page 38) or announcement up to 90
seconds (page 35).
99
(flashing) Memo recording time has exceeded the
maximum counter capacity of 99 seconds.
F
(flashing)
Memory is full. Messages must be deleted
before new messages can be received.
--
System is answering a call, being accessed
remotely, or the clock is being set.
--
(flashing)
System is being setup or initialized.
On
(or) OF
Displayed for one second when any answer-
ing system setting is turned on or off.
02
, 04, 06, tS
Current number of rings while setting
(page 36).
1-8
Displayed for two seconds while telephone
base speaker volume is being adjusted.
39
Message counter
HI
, LO, OF
Displayed for two seconds while telephone
base ringer volume is being adjusted.