ARRI WRC-1 - Manual (Page 139)

139
• Press the MODE button to go to the next submenu.
To define the fixed value for the aperture of the lens (if
controlled by the WRC-1), use the SEL and SET buttons
and the handwheel, as described above.
• Press the MODE button to go to the next submenu.
To enter the ramp duration, use the SEL and SET
buttons and the handwheel, as described above.
A previously set ramp duration may now exceed
the technically fastest possible adjustment, if the
ramp duration is simply kept from an old
program. The READY LED then flashes green
and the warning ‘SEC RANGE’ is shown in the
main menu. The ramp duration must be cor-
rected. The camera can still be started for test
purposes in spite of the flashing warning.
However, the exposure may be incorrect!
Note: The shortest possible ramp time is adjusted by
turning the handwheel to the left end-stop. The
maximum ramp time is 100 seconds.
• Press the MODE button to go to the next submenu.
The screen time for the selected ramp duration can be
displayed.
The screen time is the time (in seconds) needed for a
projection at a selected standard projection speed:
24, 25 and 30 fps are available.
• Press the SEL button for longer than 2 seconds to select
the required projection speed. Press the SEL button
repeatedly to switch between the three available values.
The selected projection speed is confirmed by pressing
the SET button.
• Press the MODE button to go back to the main menu.
Controlling the Camera Speed