Controlling the shutter angle – ARRI WRC-1 User Manual

Page 99

Advertising
background image

99

• Press the MODE button in the main menu to enter the

first submenu. The limit values (minimum and maximum
shutter angle) can be defined.
The first display line shows the start value of the shutter
angle, the second line shows the value at the end of
the ramp.

• Press the SEL button for longer than 2 seconds.

The shutter angle value in the first display line flashes.
The required value can now be set using the handwheel.
Press the SEL button again to switch to the next digit.
The first digits are confirmed, and the decimal is set to
‘0’ by pressing the SET button. The values in the
second display line can be set accordingly.

• Press the MODE button to go to the next submenu.

To define the values for the minimum and maximum
aperture (if controlled by the WRC-1), use the SEL and
SET buttons and the handwheel, as described above.
The first display line shows the start value of the aperture,
and the second line the value at the end of the ramp.

• Press the MODE button to go to the next submenu.

To define the values for the minimum and maximum
camera speed, use the SEL and SET buttons and the
handwheel. The first display line shows the start value
of the camera speed, and the second line the value at
the end of the ramp.

• If the defined values result in a constant exposure, the

display shows ‘CONST LIGHT’ when the MODE button
is pressed. If this reading is not shown, the exposure is
altered during the ramp.

Controlling the Shutter Angle

Advertising