ARRI WRC-1 - Manual (Page 148)

148
• Press the MODE button in the main menu to enter the
first submenu. The limit values for the minimum and
maximum camera speed can be defined.
The first display line shows the start value of the
camera speed, and the second line the value at the
end of the ramp.
• Press the SEL button for longer than 2 seconds.
The shutter angle value in the first display line flashes.
The required value can now be set using the handwheel.
Press the SEL button again to switch to the next digits.
The first digits are confirmed, and the decimal positions
are set to ‘0’ by pressing the SET button. The values in
the second display line can be set accordingly.
• Press the MODE button to go to the next submenu.
The limit values for the aperture of the lens can be
defined.
Both the iris and the shutter angle (only if necessary)
are automatically adjusted by the WRC-1 to compensate
the exposure while the camera speed is ramped.
The two limit values (minimum and maximum aperture)
can be selected as required.
Press the SEL button for longer than 2 seconds.
The T-stop value in the first display line flashes.
This can now be set using the handwheel.
Press the SEL button again to switch to the next digit.
The first digits are confirmed, and the decimal is set to
‘0’ by pressing the SET button. The values in the
second display line can be set accordingly.
The first display line shows the start value of the aperture,
and the second line the value at the end of the ramp.
Controlling the Camera Speed