ARRI WRC-1 - Manual (Page 17)

17
4. Setup
4.1 WRC-1 in wireless mode
In order to be able to use the WRC-1 in wireless mode, it
must be mounted on a Wireless Main Unit (WMU-1). The
Wireless Main Unit supplies the WRC-1 with power and
establishes the radio link with the camera.
An Universal Motor Controller (UMC-1) with an Universal
Radio Module (URM-1) must be mounted on the camera.
The UMC-1 and the URM-1 establish the radio link
outgoing from the camera. A Lens Control Motor CLM-2
for controlling the iris can be connected to the Universal
Motor Controller UMC-1.
For details about setting up the LCS components, refer
also to the LCS instruction manual.
Note: In order to operate the WRC-1 the following
EPROM versions must be used:
WMU-1:
01.50 or higher
UMC-1: 01.50 or higher
ARRIFLEX 435 2.4 or higher
Please contact your nearest ARRI dealer or one of the
service stations to update the EPROMs or to acquire the
latest software version.
Required system components:
WRC-1 .................................................... K2.52087.0
WMU-1 ................................................... K2.52052.0
with WBU-2 battery .................................. K2.52088.0
WAC-1 charger ........................................ K2.52072.0
UMC-1 .................................................... K2.52040.0
with UC-C1 cable [K2.52046.0 as replacement]
dovetail adapter ....................................... K2.52080.0
URM-1 ..................................................... K2.52048.0
UC-R1 cable ............................................. K2.52079.0
for iris control additionally
CLM-2 ..................................................... K2.52036.0
possibly with console ................................. K2.52035.0
Note: CLM-1 motors cannot be used
as iris motors for the WRC-1!
Setup