Konica Minolta QMS magicolor CX Reference - Manual (Page 122)

Updating System
Software
QMS magicolor CX Reference Guide 2-48
Downloading System Software to a
Functional Printer—SYSTEMDL.PS
If the print system software is non-functional (the printer can’t start
up), go to “Downloading System Software to a Non-Functional
Printer” on page 56.
If the print system software is functional (the printer starts up nor-
mally, and
IDLE displays in the message window), and if you decom-
pressed the file SYSTEMDL.PS in the previous section, use these
instructions.
Before You Begin Downloading the Software
n
Ensure that the system software is decompressed, as described
in the previous section.
n
Turn on the printer, wait for IDLE to appear in the message win-
dow, and then print an advanced status page.
This procedure may change the current configuration settings.
The advanced status page provides a record of all current config-
uration settings, so you can verify them, and reconfigure them, if
necessary, after the system software has been updated.
n
Ensure that the Administration/Communications/ Interface/Emula-
tion menu (where Interface is the interface you plan to use to
download the system software), is set to ESP or PostScript.
n
Ensure that the printer is on line and idle.