Konica Minolta QMS magicolor CX Reference - Manual (Page 45)

Administration
Menu
1-37 Printer Configuration
Enhanced Mode
Increases the resolution of a downloaded character.
Menu
Administration
Emulations
HPGL
Enhanced Mode
Choices
On—Uses an increased resolution for the grid
Off (default)—Uses standard resolution for the
grid
Notes: The HP-GL user-defined character (UC) command downloads and
draws characters with an encoding scheme that uses pen control
movements and coordinate sequences. The characters are drawn on a
grid that is superimposed on the character plot cell.
Expand Mode
Defines a larger imageable area for the selected media type. This
increased imageable area affects the default placement of the
scaling points P1 and P2.
Menu
Administration
Emulations
HPGL
Expand Mode
Choices
On—Expands the imageable area.
Off (default)—Doesn’t expand the imageable
area.
Notes: Setting this option to On partially determines the range of plotter
units for a selected media type. When the plotter senses the media type, it
automatically sets the hard clip limits to 0.591"/15 mm on three sides and
to 1.537"/39 mm on the fourth side. However, if Expand Mode is set to On,
then the limits are set to 0.197"/5 mm on three sides and 1.143"/29 mm on
the fourth side.
The HP-GL emulation senses the media size when the Paper Type is set
to Scale to Paper or when it is set to a particular media size through the
control panel or through a QMS Document Option Command.
Paper Type
Identifies the original image’s paper size.
Menu
Administration
Emulations
HPGL
Paper Type
Choices
Scale to Paper (default), A (letter/8.5"x11.0"), A4
(210x297 mm), B (11.0"x17.0"), A3 (297x420
mm)