Konica Minolta QMS magicolor CX Reference - Manual (Page 31)

Administration
Menu
1-23 Printer Configuration
End Job Mode
Enables (and identifies an end-of-job sequence) or disables data
stream sensing for the end-of-document (EOD) command.
Menu
Administration
Communications
Serial
End Job Mode
Choices
None (default)—The printer recognizes only the
PostScript ^D command.
QMS EOD—The printer recognizes only the
QMS %%EndOfDocument command.
HP EOD—The printer recognizes only the HP
<ESC>%12345X command.
Baud Rate
Sets the rate data is transmitted (bits per second) over the serial
interface.
Menu
Administration
Communications
Serial
Baud Rate
Choices
300, 600, 1200, 2400, 4800, 9600 (default),
19200, 38400
Notes: Baud rates of 19200 and 38400 require that both RTS and CTS
hardware flow control (Administration/Communications/Serial/Hdwe Flow
Ctl menu) be selected. These baud rates do not support XON/XOFF
software flow control.
Parity
Sets the check bit used to identify data transmission errors.
Menu
Administration
Communications
Serial
Parity
Choices
None (default), Odd, Even
Notes: The printer’s parity setting must match that of the host or
application. Use the Administration/Communications/Serial/Ignore Parity
menu to specify how the printer handles parity errors.