AT&T E2728B - Manual (Page 11)

7
Getting Started
7
Getting Started
Battery installation & charging
After battery installation, place the cordless handset in the base or charger and allow
to charge for at least 16 hours before use. You can keep the battery charged by return-
ing the cordless handset to the base or charger after each use. When the battery is fully
depleted, a recharge takes about 16 hours. The talk time on a fully charged battery is about
four hours depending on environmental conditions, and the standby time is approximately
five days. Actual battery life will depend on usage conditions, and age of battery.
Plug the battery pack
connector securely
into the plug inside
the cordless handset
battery compartment,
matching the color-
coded label. Then
place battery pack
into compartment.
Low battery indicator.
Return cordless handset to
base or charger to recharge
when this symbol flashes. ( The
in use cordless handset will
beep when battery is low).
Caution: Use only the supplied
rechargeable battery or AT&T
replacement battery model 3301 (SKU
91076, Part Number 80-5071-00-00).
Press down on tab to
open the battery door.
Slide the battery door up
to close.
Place cordless handset in base
or charger to charge for at least
16 hours before first use.
Plug charger power
adapter into jack on
underside of charger,
then plug adapter into
electrical outlet.
1 4
BATTERY LOW
--1--
0 8/12 10:06 AM